1. Kymco
  2. Manuel atelier
  3. mxu 500 irs efi Manuel atelier
  4. Page 188

mxu 500 irs efi Manuel atelier : Page 188

Microfiches
Image preview

Page 186

Image preview

Page 187

Image preview
Image preview

Page 189

Image preview

Page 190

1 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 175 180 185 190 195 200 205 210 215 220 225 230 235 240 245 250 255 260 265 270 275 280 285 290 295 300 305 310 315 320 325 330 335 340 345 350 355 360 365 370 375 380 385 390 395 400 405 410 415 420 425 430 435 440 445 448 
          10. DRIVE PULLEY/DRIVEN PULLEY/CLUTCH                                           MXU 500IRS


DRIVE PULLEY, DRIVE V-BELT
AND DRIVEN PULLEY
REMOVAL/INSPECTION/
INSTALLATION
                                                                 Drive Pulley Holder
 REMOVAL

 Use the special tool to hold the drive pulley,
 then remove the nut and washer.

 Special tool:
    Drive pulley holder          A120E00058

 Remove the drive pulley.
                                                  Drive Pulley          Nut/Washer


                                                                  Nut
 Use the special tool to hold the driven
 pulley, then remove the nut.

 Special tool:
    Y-type holder                A120E00056

 Remove the driven pulley and V-belt.




                                                           Y-type Holder


 Remove the driven pulley washer.                 Drive Pulley Face     Stopper Lever Shaft Nut
 Remove the drive pulley face.
 Do not loosen the stopper lever shaft nut,
   it may cause stopper lever bolt loosen.
   To tighten the stopper lever bolt must
   remove the crankcase (refer to the
   "TRANSMISSION REMOVAL/
   INSPECTION/INSTALLATION"
   section in the chapter 11).




                                                                           Washer




10-5
 Microfiches.net - Catalogue de pièces détachées de toutes marques