17. IGNITION SYSTEM Downtown 300I ABS A .C. GENERATOR INSPECTION CRANK POSITION SENSOR INSPECTION This test is performed with the stator installed in the engine. Remove the seat and met-in box. Disconnect the Crank Position Sensor Wire Coupler. Measure the resistance between the Crank Position Sensor Wire Coupler blue/white and green/white wire terminals. Blue/YellowGreen/White 11515 TILT SWITCH INSPECTION Support the scooter level surface. Put the side stand up and engine stop switch is at "RUN". Turn the ignition switch to "OFF". Remove the screws, washers and tilt switch. Do not disconnect the tilt switch connector during inspection. The capacity of battery must be fully charged. Place the tilt switch vertical as shown at the ignition switch "ON". Measure the voltage as below. Terminal Standard Violet/Red (+) Green/Pink (-) 5 V (ECU voltage) Black/Blue (+) 0.41.4 V less Green/Pink (-) Tilt Switch "UP" Mark Screws Incline the tilt switch 6510 degrees to the left or right at the ignition switch "ON". Measure the voltage as below. Terminal Standard Violet/Red (+) 5 V (ECU voltage) Green/Pink (-) Black/Blue (+) 3.74.4 V Green/Pink (-) If repeat this test, first turn the ignition switch to "OFF", then turn the ignition switch to "ON". Connector 17-4