12. FRONT WHEEL/FRONT BRAKE/FRONT SUSPENSION/STEERING SYSTEM Mongoose/KXR 90/50 ASSEMBLY Apply grease to a new dust seal lip and install the dust seal. Pack all bearing cavities with grease. Drive in the left bearing. Install the distance collar. Drive in the right bearing. · Do not allow the bearings to tilt while driving them in. Outer Driver Driver Handle · Drive in the bearing squarely with the sealed end facing out. Special Oil seal and bearing install E014 INSTALLATION Reverse the "FRONT WHEEL REMOVAL" procedures. Apply the grease onto the bearings and oil seal lips of the wheel hub. Install wheel hub, side collar, washer and tight the nut (wheel hub). Torque: 5.56.5kgf-m Install cotter pins and nut cover. Always use a new cotter pin. Do not loosen the axle nut after torque tightening. If the axle nut groove is not aligned with the cotter pin hole, align groove with the hole by tightening up on the axle nut. Install the front wheel and tighten the nuts (wheel). Torque: 4.05.0kgf-m 12-7