19. LIGHTS/SWITCHES MXU 250R/300R NEUTRAL/REVERSE SWITCHES INSPECTION Disconnect the neutral/reverse switch wire connector. (See page 6-4 or 6-10) Check for continuity between the switch side connector terminal and engine ground. NEUTRAL SWITCH There should be continuity with the transmission in neutral and no continuity with it in any gear except neutral. REVERSE SWITCH There should be continuity with the transmission in reverse and no continuity with it in any gear except reverse. Set Plates Neutral/Reverse Switch REPLACEMENT Remove drive and driven pulley. (Refer to chapter 9) Remove the two bolts and set plates. Remove neutral/reverse switch. Bolts O-ring Install a new switch with a new O-ring (apply engine oil to O-ring). Make sure that the lever on the neutral/reverse switch correctly engages with the locating slot on the shift shaft. Lever 19-7