1. GENERAL INFORMATION PEOPLE 125/150 Route harnesses so they are neither pulled tight nor have excessive slack. Symbols: The following symbols represent the Protect wires and harnesses with electrical servicing methods and cautions included in tape or tube if they contact a sharp edge or this service manual. corner. When rubber protecting cover is used to protect the wire harnesses, it shall be installed securely. Do not break the sheath of wire. : Apply engine oil to the specified points. (Use If a wire or harness is with a broken sheath, Engine Oil designated engine oil for repair by wrapping it with protective tape lubrication.) or replace it. When installing other parts, do not press or squeeze the wires. Grease : Apply grease for lubrication. After routing, check that the wire harnesses are not twisted or kinked. : Transmission Gear Oil (90#) Gear Oil Wire harnesses routed along with handlebar should not be pulled tight, have excessive slack or interfere with adjacent or surrounding parts in all steering : Use special tool. positions. Special When a testing device is used, make sure to understand the operating methods : Caution thoroughly and operate according to the operating instructions. Be careful not to drop any parts. : Warning When rust is found on a terminal, remove the rust with sand paper or equivalent before connecting. Do not bend or twist control cables. Damaged control cables will not operate smoothly and may stick or bind. 1-6