12. FRONT WHEEL/SUSPENSION/ STEERING STRYKER 125/150 Connect the throttle cable to the throttle grip. Throttle Cable Apply grease to the throttle cable. Install the throttle housing by aligning the pin on the housing with the punch hole in the handlebar. Then, tighten the two screws. FRONT WHEEL Speedometer Cable REMOVAL Place a floor jack or adjustable support under the engine. Jack the motorcycle front wheel off the ground. Remove the speedometer cable set nut and disconnect the speedometer cable. Remove the front brake cable. Remove the front axle nut and pull out the axle. Remove the front wheel. Axle Nut INSPECTION Set the axle in V blocks and measure the runout. The actual runout is of the total indicator reading. Service Limit: 0.2mm replace if over 12-7