18. STARTING SYSTEM GRAND DINK 125/150 ASSEMBLY Apply grease to the dust seal in the front cover. Install the brushes onto the brush holders. Apply a thin coat of grease to the two ends of the armature shaft. Insert the commutator into the front cover. Front Cover Tab Groove O-ring Install a new O-ring to the front cover. Install the starter motor case, aligning the tab on the motor case with the groove on the front cover. Tighten the starter motor case screws. Motor Case O-ring Starter Motor Cable INSTALLATION Connect the starter motor cable. Check the O-ring for wear or damage and replace if necessary. Apply grease to the O-ring and install it to the starter motor. Tighten the two mounting bolts. STARTER CLUTCH INSPECTION Refer to pages 10-4 and 10-5 for the starter clutch removal, inspection and installation. 18-5