7. COOLING SYSTEM MYROAD 700i WATER TEMPERATURE SENSOR REMOVAL Remove the side body cover Disconnect the water temperature sensor connector. Remove the water temperature sensor from the water joint. INSPECTION Connector Water Temperature Sensor Connect the water temperature sensor to the ohmmeter and dip it in oil contained in a pan which is placed on an electric heater. Gradually raise oil temperature while reading the thermometer in the pan and the Water Temperature Sensor ohmmeter connected. If the resistance measured is out of specification, replace the temperature gauge with a new one. Temperature Standard resistance 50 140310 100 24.128.2 Handle the water temperature sensor Thermometer carefully as it is vulnerable to impact. Do not allow the water temperature Multi-meter sensor and the thermometer to come in contact with the bottom of the pan. After the water temperature sensor has been installed, fill coolant and perform air bleeding. INSTALLATION Tighten the water temperature sensor. Torque: 0.8~1.2 kgf·m 7-17