people gt 300 i Manuel atelier : Page 98

          9. FINAL REDUCTION                                                                People GT 300i




 FINAL REDUCTION ASSEMBLY
                                                                            Dowel Pin
 Install the drive shaft into the left crankcase.

 Put the final gear on the left crankcase.

 Install the countershaft and gear into the left
 crankcase.

 Install the final shaft into the final gear and
 transmission case.


 Install the dowel pins and a new gasket.                    Countershaft           Final Gear


 Install the transmission case cover.
 Install and tighten the transmission case
 cover bolts.
 Install the clutch outer/driven pulley.
 Install other removed parts in the reverse
 order of removal.
 Torque:
 Transmission case bolt       0.8-1.2 kgf-m
 (9.8 N-m)



 After installation, fill the transmission case
 with the specified oil.
                                                           Transmission Case Cover
   · Place the scooter on its main stand on
     level ground.
   · Check the oil-sealing washer for wear
     or damage.

 Specified Gear Oil: SAE90#
 Oil Capacity:
   At disassembly : 0.23 liter
   At change      : 0.21 liter

 Install and tighten the oil check bolt.
 Torque:
 Oil filler/drain bolt 1.8-2.2 kgf-m (19.7 N-m)

 Start the engine and check for oil leaks.
 Check the oil level from the oil check bolt
 hole and add the specified oil to the proper
                                                    Drain Bolt (under)          Oil filler Bolt
 level if the oil level is low.


9-5