14. HYDRAULIC BRAKE STRYKER 125/150 Install the main piston and snap ring. Install the rubber cover. Install the brake lever. Place the brake master cylinder on the handlebar and install the master cylinder holder with the "UP" mark facing up, aligning the tab on the holder with the hole in the handlebar. First tighten the upper bolt and then tighten the lower bolt. Torque: 1.01.4kg-m "UP" Mark Install the brake fluid tube with the bolt and two sealing washers. Then, install the Bolt rearview mirror. Fill the brake reservoir with recommended brake fluid to the upper level. Bleed air from the hydraulic brake system. (Refer to 14 -3.) Sealing Washers 14-9