10. A.C. GENERATOR/STARTER CLUTCH GRAND DINK 125/150 Spring Roller Remove the starter one-way clutch rollers, plungers and springs. Inspect each roller and plunger for wear or damage and check for broken or weak spring. Plunger Shaft Starter Idle Gear INSTALLATION Install the starter driven gear onto the crankshaft. Install the starter idle gear and shaft. Starter Driven Gear Flywheel FLYWHEEL INSTALLATION Install the flywheel onto the crankshaft by aligning the key on the crankshaft with the groove in the flywheel. · Before installation, check and make sure that the inside of the flywheel is not contaminated. Hold the flywheel with the flywheel holder and tighten the flywheel nut. Torque: 34.339.2N-m Key Groove Flywheel Holder 10-5